Beijer-electronics SCOM RBC EN Uživatelský manuál stáhnout pdf (Strana 51)

Command Reference

Beijer Electronics, MAEN993 51

5.6.21LAU_CONFIG_SETDISPLAYGROUP

(0x01A7)

Device Group

Besides the standard addressing scheme, where the lowest four address bits in field

ADR are used to address a total count of 16 devices in a network, the Beijer Electron-

ics RBCs use also the upper four bits, which indicates a group of devices in a network

(max. 15 groups). The device grouping is activated, if the software configured device

address is used (the DIL switch settings are ignored). This function stores the new

group the device belongs to.

Supported since Firmware Version

LAUER RBC: 0.0.0.1

Command Stream

Response Message (Acknowledge)

Response Message (Negative Acknowledge)

Under normal operation conditions, a device never sends a negative acknowledge in

response to this command.

Maximum Lr for this Command

Note:

The changes made by this command will become active only after a restart of the de-

vice. This avoids loosing the connection to the device during configuration.

0 1 2 3 4 5 6 7...9 10

0x07 ADR 0x4C 0x41 0x55 0x03 ICHKH 0x01 0xA7 Param ICHKD

Param

Value: 0 ... 14

Type: Byte

Length: 1

Description: New display group to be stored

0 1 2 3 4 5 6 7 8

0x06 ADR

0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD

Ret

Value: 0 ... 14

Type: Byte

Length: 1

Description: Stored display group

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 63 64

Žádné komentáře

Beijer-electronics SCOM RBC EN Uživatelský manuál Strana 51