
Command Reference
Beijer Electronics, MAEN993 27
5.6.5 LAU_CONFIG_GETDISPLAYADR (0x010F)
Device Address
Returns the software configured device address. This address is used, if the device is
configured to override the DIL (DIP) switch settings. The returned address does not
contain group information.
Supported since Firmware Version
LAUER RBC: 0.0.0.1
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Example
Read the software configured device address (excluding group) from the device at ad-
dress 14.7 (group 14, address 7):
According to the data returned by the device at address 14.7 (group 14, address 7),
the devices software configured address without group is 0x07:
0 1 2 3 4 5 6 7...8 9
0x07 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x01 0x0F ICHKD
0 1 2 3 4 5 6 7 8
0x06 ADR 0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD
Ret
Value: 0...15 (0x00...0x0F)
Type: Byte
Length: 1
Description: Software configured device address
0 1 2 3 4 5 6 7...8 9
0x07 0xE7
0x4C 0x41 0x55 0x02 0x2D 0x01 0x0F 0xEF
0 1 2 3 4 5 6 7 8
0x06 0xE7
0x4C 0x41 0x55 0x01 0x2F 0x07 0xF8
Komentáře k této Příručce