
Command Reference
44 Beijer Electronics, MAEN993
5.6.17LAU_CONFIG_SETREMOTECONTROL
(0x019C)
Remote Control Configuration
This command returns a configuration value that indicates whether the device is con-
figured to act as a remote controller. Beijer Electronics RBCs can be used as passive
devices, but can be additionally set up as remote controller devices to alter the back-
light level of any other device within the network every time the backlight is changed
by the buttons on the front of the device.
Supported since Firmware Version
LAUER RBC: 0.0.0.1
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Note:
The changes made by this command will become active only after a restart of the de-
vice.
0 1 2 3 4 5 6 7...9 10
0x07 ADR
0x4C 0x41 0x55 0x03 ICHKH 0x01 0x9C Param ICHKD
Param
Value: 0x00: Disable remote controlling capability
0x01: Enable remote controlling capability
Type: Byte
Length: 1
Description: Decides if the device is used also as remote controller
0 1 2 3 4 5 6 7 8
0x06 ADR
0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD
Ret
Value: 0x00: Remote controlling capability is disabled
0x01: Remote controlling capability is enabled
Type: Byte
Length: 1
Description: Indicates whether the device is used also as remote controller
Komentáře k této Příručce