Beijer-electronics iX Panel TA100 EN Uživatelský manuál Strana 22

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 45
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 21
Hardware Replacement
7.4 ReplacingtheDisplay/Display
Cable
The following is needed:
A ne w display/display c able, see Available Spare Parts for iX Panel TA100
AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the s teps below to replace the display/display cable:
1.
Power off the operator panel.
2.
Follow the instructions under Replacing the Rear Cover to remove the rear
cover.
3.
Disconnect the two ex cables the flex cable and the LED cable from the
power card and remove the two plastic nuts that hold the power card in place.
LED cable
plastic nut
flex cable
plastic nut
4.
Lift the power card and gently remove the backlight cabl es and the display
cablefromtherearsideofthepowercard.
display cable
backlight cables
BeijerElectronics, MAEN013A
22
Zobrazit stránku 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 44 45

Komentáře k této Příručce

Žádné komentáře