Beijer-electronics SCOM Protocol EN Uživatelský manuál stáhnout pdf (Strana 104)

Command Reference

104 Beijer Electronics, MAEN975

6.59 LAU_CONTROL_DINCONFIG (0x0206)

Digital Input Configuration

This command configures the digital input port. The setting is temporary, and does

not change the startup digital input port configuration.

Supported since Firmware Version

MT230 Nautic Monitor: 1.0

Command Stream

0 1 2 3 4 5 6 7...9 10

0x07 ADR 0x4C 0x41 0x55 0x03 ICHKH 0x02 0x06 Param ICHKD

Param

Value: 0x00: Command “No operation”

0x01: Command “Set brightness”

0x02: Command “Special functions 1”

0x03: Command “Special functions 2”

Type: Byte

Length: 1

Description: Command to be assigned to the digital I/O port.

The commands are specified as follows:

No operation

No function assigned to the digital input pins.

Set brightness

Input bits 0…2: Eight predefined backlight level values.

These values can be configured.

Special functions 1

Input bits 0…1: Route the value of input pins 0 and 1 to

the output pins 0 and 1.

Input bit 2: 1: Enable analog input to backlight level

control routing.

0: Disable analog input to backlight level

control routing.

Special functions 2

Input bit 0: 1: Enable ECDIS mode.

0: Disable ECDIS mode.

Input bit 1: 1: Enable POT mode.

0: Disable POT mode.

Input bit 2: 1: Disable OSD (video controller) keys.

0: Enable OSD (video controller) keys.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 130 131

Žádné komentáře

Beijer-electronics SCOM Protocol EN Uživatelský manuál Strana 104